Hyundai Sonata LF: Crash Pad / Crash Pad Under Cover Repair procedures
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
| • |
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
| • |
Take care not to bend or scratch the trim and panels. |
|
| 1. |
Using a screwdriver or remover, remove the crash pad under cover [RH] (A). 
|
| 2. |
Disconnect the under lamp connector (A). 
|
| 3. |
Install in the reverse order of removal.
| • |
Make sure the connector is connected properly. |
| • |
Replace any damage clips. |
|
|
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Other information:
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification : Refer to “Specification”
Removal
1.
Turn the ignition seitch OFF and disconnect the battery negative (-) cable...
Inspection
•
Wrap the protective tape on the tool to disassemble with the screwdriver or remover.
•
Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil...
Crash Pad Side Cover Repair procedures
