Hyundai Sonata LF: AVN System / AVN Remote Controller Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / AVN System / AVN Remote Controller Repair procedures

Inspection
1.
Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
SEEK Up
2-5
430 ?
SEEK Down
1.11 k?
MODE
2.11 k?
MUTE
3.11 k?
Volume (+)
4.61 k?
Volume (-)
6.81 k?
Voice
10.71 k?
SEND
18.91 k?
END
40.91 k?

2.
Check for resistance between terminals in each switch position (RH).

[RH : Audio + Hands free]
Switch
Connector
Terminal
Resistance
(±5%)
Cancel
3-5
330 ?
SET -
550 ?
RES +
880 ?
Cruise ON/OFF
1.44 k?
SCC (Following distance control)
5.54 k?
Group
2-5
560 ?
Trip Up
890 ?
Trip Down
1.45 k?
ENTER
2.55 k?

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
3.
Remove the screw from the steering cover.

4.
Remove the steering back cover (A).

5.
Remove the steering remote control connector (A).

6.
Remove the steering remote control (A) after loosening the screws.

Installation
1.
Install the steering wheel remote control after connecting the connector.
2.
Connect the negative (-) battery terminal.

    AVN Remote Controller Schematic Diagrams

    C..

    AVN Remote Controller (Sonata Sports) Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Electric WGT Control Actuator Description and Operation


    Desrcription The Electric WGT Control Actuator is installed on the turbocharger.It operates the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount by the ECM's PWM signal. This actuator consists of a DC motor which actuates the vane, a 2-step gear which increases torque of the DC motor, a position sensor which detects status of the vane, an electric control unit which drives the DC motor...

    Hyundai Sonata LF 2014-2019 Service Manual: Evaporator Temperature Sensor Description and Operation


    Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC)...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org