| Inspection |
| [Measuring Resistance] |
| 1. |
Disconnect the smart cruise control switch connector from the control switch.
|
| 2. |
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
|
| 3. |
If not within specification, replace switch. |
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel") |
| 3. |
Remove the screw from the steering cover.
|
| 4. |
Remove the steering back cover (A).
|
| 5. |
Remove the steering remote control connector (A).
|
| 6. |
Remove the steering remote control (A) after loosening the screw.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Side Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side Body B * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Fender apron tooling hole (O7)Fender apron panel tooling hole (O7)Front door upper hinge mounting hole (O13)Front door lower hinge mounting hole (O13)Rear door upper hinge mounting hole (O13)Rear door lower hinge mounting hole (O13)Quarter panel tooling hole (O14)Quarter fixed glass mounting hole (O5...