| Removal |
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 2. |
Disconnect the fuel sender connector (A).
|
| 3. |
Remove the fuel sender (A) after releasing the fix hook.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pump Motor Repair proceduresRemoval 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A), and the fuel sender connector (B)...
Fuel Pressure Regulator Repair proceduresRemoval 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Remove the fuel pressure regulator fixing clip (A). 3. Remove the fuel pressure regulator (B) from the fuel filter...
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer to “Specification” ETC Motor 1...
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH). Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location...