| Replacement |
|
|
| 1. |
After loosening the mounting clips, then remove the front door quadtant inner cover (A).
|
| 2. |
Using a flat-tip or remover, remove the front door pull cap (A).
|
| 3. |
Pull the front door inside handle using a flat head
screwdriver and remove the cap (A) using the hole located inside of the
handle.
|
| 4. |
After loosening the mounting screws, then remove the front door trim (A) by using a flat-tip screwdriver.
|
| 5. |
Remove the front door inside handle cage (A). |
| 6. |
Remove the front door extension connector (B).
|
| 7. |
Install in the reverse order of removal.
|
Front Door Inside Handle Repair proceduresReplacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. After loosening the mounting screws, then remove the front door inside handle (A)...
Remove and Installation 1. Remove the cylinder head assembly. (Refet to Cylinder Head Assembli - "Cylinder Head") 2. Remove the water jacket seperator (A). Be careful not to deform or damage it when removing. 3. Install in the reverse order of removal...
Replacement [Center Pillar Lower Trim] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...