| Removal and Installation |
| 1. |
Remove the engine cover (A).
|
| 2. |
Install in the reverse order of removal. |
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting cap (A). 4. Remove the installation bolt (A), and then remove the accelerator pedal module...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1...