| Description |
Never attempt to measure the circuit resistance of the airbag
module even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury. |
Side Airbag (SAB) Module Repair proceduresRemoval The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag...
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the knee air bag. (Refer to Restraint - "Knee Airbag(KAB) Module") 4. Disconnect the stop lamp switch connector (A), and than remove stop lamp switch...
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line...