Hyundai Sonata LF: General Information / Basic Service Symbols

Hyundai Sonata LF 2014-2019 Service Manual / General Information / Basic Service Symbols

General Information

There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service.
Symbol
Meaning

Do not reuse the part. Replace a new one.

Apply engine oil or transmission oil to the part.

Apply automatic transmission fluid (ATF) to the part.

Apply grease to the part.

Apply sealant to the part.

    General Tightening Torque Table

    General Information Tightening Torque Table Of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg...

    General Service Information

    General Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.     The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Relay Box (Passenger Compartment) Description and Operation


    Description Auto Cut System Of Dark Current AbbreviationExpalnationACUAirbag Control UnitADMAssist Door ModuleB_CANBody Controller Area NetworkBCMBody Control ModuleBSDBlind Spot DetectionC_CANChassis Controller Area NetworkCLUCluster ModuleDATCDual Automatic Temp ControlDDMDriver Door ModuleESCElectronic Stability ProgramEMSEngine Management SystemLDWSLane Departure Warning SystemM_CANMulti media Controller Area NetworkMDPSMotor Driven Power SteeringP_CANPowertrain Controller Area NetworkPSMPower Seat ModuleSASSteering Angle SensorSJBSmart Junction BlockSMKSmart Key UnitSPASSmart Parking Assist SystemTCUTransmission Control UnitTPMSTire Pressure Monitoring SystemVDCVehicle Dynamic ControlTMUTelematics SystemABSAnti-lock Brake SystemSCCSmart Cruise Control Smart Junction Block (SJB) General function : Interior Junction Block + some functions of BCM It controls loads with CAN communication and IPS...

    Hyundai Sonata LF 2014-2019 Service Manual: Boost Pressure Sensor (BPS) Repair procedures


    Inspection 1. Connect a GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org