Hyundai Sonata: Starting System / Starter Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation

Description

The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.

When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.

The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.The contacts close and the starter motor cranks.

In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

In conjunction with the ISG function, the starter motor must do a great deal more work. Therefore, the starter motor is configured for a significantly higher number of start cycles. The components of the starter motor have been adapted to the higher requirements.

1. Solenoid
2. Brush
3. Armature
4. Overrun clutch

Troubleshooting

Troubleshooting • The battery must be in good condition and fully charged for this troubleshooting. ...

Starter Specifications

Specification ItemSpecificationRated voltage12 V, 0.9 kWThe number of pinion teeth10Performance[No-load, 11.5 V]AmpereMax. 60 ASpeedMin. 5,500 rpm ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Rear Wheel Speed Sensor Repair procedures
Removal 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap(A). Be careful not to damage to the wheel cap(A) when removing the it. 3. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9. ...

Hyundai Sonata LF 2014-2019 Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manif ...