Hyundai Sonata: Tires and Wheels / Low Aspect Ratio Tires

Low aspect ratio tires, the aspect ratio is lower than 50, are provided for sporty looks.

Because low aspect ratio tires are optimized for handling and braking, it may be more uncomfortable to ride in and there is more noise compare with normal tires.

CAUTION

Because the sidewall of the low aspect ratio tire is shorter than the normal, the wheel and tire of the low aspect ratio tire is easier to be damaged. So, follow the instructions below.

- When driving on a rough road or off road, drive cautiously because tires and wheels may be damaged. And after driving, inspect tires and wheels.

- When passing over a pothole, speed bump, manhole, or curb stone, drive slowly so that the tires and wheels are not damaged.

- If the tire is impacted, we recommend that you inspect the tire condition or contact an authorized HYUNDAI dealer.

- To prevent damage to the tire, inspect the tire condition and pressure every 1,800 miles (3,000km).

CAUTION

Radial-Ply Tires
Radial-ply tires provide improved tread life, road hazard resistance and smoother high speed ride. The radial- ply tires used on this vehicle are of belted construction, and are selected to compleme ...

Fuses
A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 (or 3) fuse panels, one located in the driver's side panel bolster, the other in the engine ...

Other information:

Hyundai Sonata LF 2014-2019 Owners Manual: On curves
The Smart Cruise Control System may not detect a moving vehicle in your lane, and then your vehicle could accelerate to the set speed. Also, the vehicle speed will decrease when the vehicle ahead is recognized suddenly. Select the appropriate set speed on curves and apply the brakes or accel ...

Hyundai Sonata LF 2014-2019 Service Manual: General Tightening Torque Table
General Information Tightening Torque Table Of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg.m, Ib-ft) Nominal diameter. (mm)Pitch [mm (in.) ]4T8T10TM50.8 (0.031) 2.0 ~ 3.0 (0.2 ~ 0.3, 1.4 ~ 2.2) 4.9 ~ 6.9 (0.5 ~ 0.7, 3.6 ...

© 2018-2024 www.hsonatalf.org