| Inspection |
| [Measuring Resistance] |
| 1. |
Disconnect the cruise control switch connector from the control switch.
|
| 2. |
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
|
| 3. |
If not within specification, replace switch. |
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel") |
| 3. |
Remove the screw from the steering cover.
|
| 4. |
Remove the steering back cover (A).
|
| 5. |
Remove the steering remote control connector (A).
|
| 6. |
Remove the steering remote control (A) after loosening the screw.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Front Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body B * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body C * These dimensions indicated in this figure are actual-measurement dimensions...
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting cap (A). 4. Remove the installation bolt (A), and then remove the accelerator pedal module...