| Oil Specification |
| 1. |
The R-134a system requires synthetic (ND8) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed. |
| 2. |
Compressor (ND8) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
|
| 1. |
The oil should be free from moisture, dust, metal powder, etc. |
| 2. |
Do not mix with other oil. |
| 3. |
The water content in the oil increases when exposed to air.
After use, seal oil from air immediately. (R-134a Compressor Oil absorbs
moisture very easily.) |
| 4. |
The compressor oil must be stored in steel containers, not in plastic containers.
|
Oil total volume in system
ND8 (PAG): 80 ± 10 cc (2.82 ± 0.3 oz.) |
| 1. |
Open all the doors and engine hood. |
| 2. |
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position. |
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system. |
| 4. |
Stop the engine. |
Components and Components LocationComponent Location Index Engine Room [Theta 2.4 GDI] 1. Receiver-drier2. Condenser3. Service Port (High Pressure)4. Service Port (Low Pressure)5...
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mounting screws (2EA)...
Description Steering Wheel Angle Sensor detects rotating direction of the vehicle. Rotating direction detected by the sensor is communicated with HECU as CAN signal involving information about the angle through CAN communication line. HECU detects speed of the steering wheel handling and the angle with this CAN signal...