Hyundai Sonata: Warning Lights / Engine Oil Pressure Warning Light

This warning light illuminates:

If the engine oil pressure is low:

1. Drive carefully to the nearest safe location and stop your vehicle.

2. Turn the engine off and check the engine oil level (For more information, refer to "Engine Oil" in chapter 7). If the level is low, add oil as required.

If the warning light remains on after adding oil and restarting the engine or if oil is not available, turn off the engine. There is a mechanical concern that needs to be repaired before you can continue driving. In this case, have your vehicle inspected by an authorized HYUNDAI dealer.

NOTICE

- Engine Oil Pressure Warning light

To prevent severe engine damage, after the Engine Oil Pressure Warning Light is illuminated and as soon as it is safe to do so, turn the engine off and check the oil level.

If the oil level is low, fill the engine oil to the proper level and start the engine again. If the light stays on with the engine running, turn the engine off immediately.

In this case, have your vehicle inspected by an authorized HYUNDAI dealer.

Charging System Warning Light
If this warning light comes on while the engine is running, the battery is not being charged. Immediately turn off all electrical accessories. Try not to use electrically operated controls, such as ...

Low Fuel Level Warning Light
This warning light illuminates: When the fuel tank is nearly empty. Add fuel as soon as possible. NOTICE - Low Fuel Level Driving with the Low Fuel Level warning light on or with the fuel level below ...

Other information:

Hyundai Sonata LF 2014-2019 Owners Manual: Sunvisor
To use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward, unsnap it from the bracket (1) and swing it to the side (2). To use the vanity mirror, pull down the sunvisor and slide the mirror cover (3). Adjust the sunvisor forward or backward (4) as needed. Use the t ...

Hyundai Sonata LF 2014-2019 Service Manual: Power Door Mirror Actuator Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door quadrant inner cover (A). 3. Disconnect the power door mirror connector from the harness. 4. Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly. ...

© 2018-2025 www.hsonatalf.org